Hummer Power Seat Switch

What does the power seat switch?

A power seat switch allows the driver or passenger to adjust the position of their seat electronically. Instead of manually adjusting the seat's position using levers or knobs, a power seat switch enables users to control the movement of the seat using buttons or switches. Power seat switches are usually located on the side of the seat or on the door panel. It contributes to the convenience and comfort of driving or riding in a vehicle by providing customizable seating positions for users of varying sizes and preferences.

Power seat switch replacement

Tools and materials you might need

• Replacement power seat switch
• Screwdrivers (flathead and Phillips)
• Pliers
• Trim removal tools
• Socket set
• Electrical contact cleaner
• Shop towel or rag

Specific steps

1. Prepare the vehicle

• Make sure the vehicle is parked in a safe and level area.
• Disconnect the negative terminal of the vehicle's battery to prevent accidental electrical short circuits.

2. Remove trim panels

Carefully remove any trim panels or covers around the power seat switch area. Use trim removal tools to avoid damaging the panels or upholstery. Some panels might be secured with screws or clips. Use appropriate tools to remove them.

3. Disconnect wiring

• Locate the wiring harness connected to the power seat switch. It might be necessary to remove more trim or panels to access the wiring.
• Gently disconnect the wiring harness from the switch. If there's a locking tab, release it before pulling the connector.

4. Remove the old switch

• Depending on the switch design, it might be secured with screws, clips, or a combination of both.
• Use appropriate tools to remove any screws holding the switch in place. If there are clips, carefully release them using a flathead screwdriver or pliers.

5. Install the new switch

• Position the new power seat switch in place, aligning it with the screw holes or clips.
• If applicable, secure the switch using screws or re-attach any clips that were removed earlier.

6. Connect wiring

Plug the wiring harness connector into the new power seat switch. Ensure a secure connection.

7. Test the switch

• Reconnect the negative terminal of the vehicle's battery.
• Test the new power seat switch to ensure that all functions work properly, including seat movement and adjustments.

8. Reassemble trim panels

Carefully reattach any trim panels or covers that were removed. Press clips into place and secure screws as needed.

9. Final Check

Sit in the seat and test all the functions once again to confirm everything is working as expected.

10. Dispose of old switch

If the old power seat switch is no longer functional, dispose of it properly according to local regulations.