Buy Mercury Spark Plug Wire

Page 1 of 7

What are spark plug wires?

Spark plug wires, also known as ignition cables or spark plug leads, are a set of wires that connect the ignition coil or distributor to the spark plugs in an internal combustion engine. They are responsible for transmitting high-voltage electrical energy from the ignition source to the spark plugs, which ignite the fuel-air mixture in the engine's cylinders.

The spark plug wires typically consist of a central core made of conductive materials such as copper, and an insulating layer made of materials like silicone or rubber to prevent electrical current from leaking. The wires are designed to withstand high temperatures and electrical interference and are often color-coded to ensure correct installation.

Signs of bad spark plug wires

Spark plug wires play a crucial role in ensuring reliable engine performance. Worn or damaged spark plug wires can cause misfires, rough idling, and poor fuel efficiency, so it's important to take regular maintenance and replace them as needed.

Engine knocking

When the spark plug wires fail, the engine may produce a knocking sound, particularly under heavy loads. This can be caused by pre-ignition or detonation, which can occur when the spark plug wires are not delivering enough energy to the spark plugs.

Rough shifting (automatic transmission)

In some cases, a damaged spark plug wire can cause rough shifting in an automatic transmission. This can be due to a drop in engine power caused by misfires or other problems related to the spark plug wires.

Burned spark plug wires

If you notice that your spark plug wires are discolored or burned, this can be a sign that they are not functioning properly. Burned spark plug wires can be caused by excessive heat, electrical interference, or other issues.

Poor acceleration

When the spark plug wires are failing, the engine may have trouble accelerating smoothly. This can be due to misfires or other problems related to the spark plug wires.

Stalling

A damaged spark plug wire can cause the engine to stall or cut out, particularly at idle. This can be due to a drop in engine power caused by misfires or other problems related to the spark plug wires.

How to change spark plug wires?

Replacing a spark plug wire set is a relatively simple task, and can usually be completed in under an hour. You can follow these steps:

1. Remove the worn or faulty spark wire set.

To avoid confusion and prevent accidentally switching the wires, it is recommended to replace each spark plug wire individually, starting with the longest one. When removing the wires from either the spark plug or distributor cap, it is important to loosen the connection by twisting or rotating the boot. Yanking or forcefully pulling on the wires may cause them to break. Only pull on the boot and refrain from pulling on the cable.

2. Install the new spark plug wire set

Install the new spark plug wires in the same location as the old wires, making sure to connect each wire to the correct spark plug. If your new spark plug wires have boots, be sure to push the boot firmly onto the spark plug until it clicks into place.

3. Test the new spark plug wires

Once you have installed the new spark plug wires, start the engine and check for any signs of misfires, rough idling, or other problems that could indicate an issue with the spark plug wires. If everything looks good, you're all set!

Spark Plug Wire

What are spark plug wires?

Signs of bad spark plug wires

How to change spark plug wires?

Shop By Mercury Models

Shop By Mercury Years