Volvo Brake Pad

Volvo Brake Pads For A Defined Repair

Volvo brake pads can be purchased for a defined axle repair or as a front-and-rear set. A combined ceramic set covers both ends of the vehicle, while individual pad specifications still belong to their assigned positions. Compare coverage and supplied fittings after checking the installed brake arrangement. The retained discs, calipers and supports also need inspection, especially when noise or unusual wear prompted the decision to replace the pads.

Read Pad Backing And Friction Materials Separately

An iron backing plate is separate from the pad's friction material. That material supports the friction layer and should be read separately from the pad's working compound.

The backing plate supports the friction material and transfers the caliper's clamping force through the pad. Its outline, tabs and contact points must fit the pad supports and caliper. The friction compound bonded to that plate has a separate material description, so an iron backing does not mean the friction face is iron. When comparing pads, look at the complete assembly: the backing shape establishes where it fits, the compound forms the working surface, and shims or clips serve their own fitting functions.

Find The Cause Of Brake Noise

Brake noise can come from the friction surfaces, fitting hardware or movement of related components. Have the sound assessed along with pad wear, rotor condition and the caliper supports. A worn clip, contamination or a component that binds may need correction during the same repair. Choose new friction parts for the identified brake application, then include the fitting items the job requires. This approach addresses the cause of the complaint instead of relying on a material description to guarantee silence from the entire assembly.

Match Pads To Any Changed Brake Equipment

Replacement compatibility is based on the vehicle equipment described in the entry. If a previous owner changed the calipers, rotors or wheel-end assembly, identify the components now installed before ordering factory-application service parts. Records from the modification can help establish the correct combination. A wheel change alone does not identify a new brake specification, while a brake conversion may change several components together. Have the installer resolve the current assembly and its service requirements so that the replacement purchase matches the brakes actually on the vehicle.

Plan Initial Use Of Replacement Volvo Pads

Bedding in is the initial-use process for new friction surfaces after the installation has been checked. Follow the instructions for the vehicle and fitted components, since one sequence of stops or speeds is not suitable for every brake setup. The installer should first establish normal brake operation and complete the required checks. Pulling, a soft pedal or reduced braking calls for diagnosis before further driving. Bedding is intended for a functioning assembly; it is not a way to correct a mechanical or hydraulic fault.

Frequently Asked Questions (FAQ)